Loop Telecom IP6610 User Manual

Chapter 21 Appendix A: Operation Commands
142
Command: >set vlan remove
Syntax: set vlan remove vid interface-name
Explanation: remove a bridge interface from a specific VLAN.
Parameters: vid (VLAN ID, range from 1 to 4094)
Tag-type: tagged or untagged
Interface-name: such as “lan1”, “wan1”, or “wan1 pvc1”….
Command: >set vlan regencrc
Syntax: set vlan regencrc action
Explanation: Enabling this feature will cause all wan interfaces(virtual channels) to regenerate CRC
value
on the WAN links. Note: This will reduce the performance for bridge forwarding.
(Default: disabled)
Parameters: action: enabled or disabled
Command: >set wan modem init
Syntax: set wan modem init
Explanation:
Set up the initial at command.
Parameters:
initial at
command
initial at command
(default:”AT”，less than 32 characters )
Command: >set wan modem dial
Syntax: set wan modem dial setting
Explanation:
Enable/Disable the auto-dial feature
Parameters:
setting enable/disable
Command: >set wan modem phone
Syntax: set wan modem phone phone number
Explanation:
Set up the phone number for auto-dial.
Parameters:
phone number
phone number (less then 32 digits)
Command: >set wan modem hangup
Syntax:
set wan modem hangup
Explanation:
Send the hang up AT command to modem directly
Parameters:
Command: >set wan modem timeout
Syntax: set wan modem timeout timeout value
Explanation:
timeout value in secs
Parameters:
timeout
value
use “0” to disable timer , default:30 secs , maximum: 7200 secs
Command: >set wan modem debug
Syntax: set wan modem debug setting
Explanation:
Enable/Disable the modem debug message
Parameters:
setting enable/disable
Command: >set wan1 chdlc
Syntax: set wan1 chdlc interval timeout

Loop Telecom IP6610 Specifications

General

Brand	Loop Telecom
Model	IP6610
Category	Network Router
Language	English