3-53
[11] CHECKING HORN FOR OPERATION
1. Turn the starter switch to the “ON” position and check the
followings.
2. Press the horn switch to verify that the horn sounds.
If not, the horn may be faulty or the circuit may be open.
Ask us or our sales service agency for repair.
[12] CHECKING HEADLIGHTS FOR OPERATION
1. Turn the starter switch to the “ON” position and check the
followings.
2. Push the headlight switch in the back and verify that the pilot
lamp of the switch section and the headlight on front of the
machine lights up.
If it does not light up, the bulb may be burned or the circuit may
be open. Ask us or our sales service agency for repair.
[13] CHECKING FUSE BOX FOR DAMAGE
If fuses are brown frequently or if you find the trace of a short circuit created in the electrical
wiring, be sure to find the cause and fix the problem.
Check the fuse at the lower section of the instrument panel for
damage and meltdown and if the fuse of specified capacity is being
used.
If a fuse has melted down or the trace of an open/short circuit is
found in the electrical wiring, ask us or our sales service agency for
repair.
To Next Page
Loading...
