3-85
3. Operate the work selector switch on the outrigger operation
panel to the ”OUTRIGGER” position.
4. Verify that the boom stowing lamp (1) (green) on the outrigger
display is ON.
5. Pull the position pin (1) out of the rotary (2) and rotate the rotary
outward.
6. Insert the position pin (1) to the end at the position where the pin
holes are aligned after rotating the rotary (2) outward.
NOTES
The position pin (1) has a wire to prevent the loss of the pin.
7. Perform the same preparatory task to the other three outriggers.
NOTES
After completing the preparatory task, verify that the position pin
(1) is securely inserted.
8. Verify that the four outrigger extension lamps (2) (green) on the
outrigger display are ON.
NOTES
The boom stowing lamp (1) and four outrigger extension lamps
(2) on the outrigger display are ON.
To Next Page
Loading...
