3-86
[2] TASKS TO BE PERFORMED AFTER STARTING ENGINE
The overturning alarm buzzer sounds if the machine tilts for “3 degrees” or more when setting
the outriggers. Operate the outrigger switches and adjust the machine to be leveled in which
state the alarm buzzer will not sound.
1. See “Operation 2.2 Starting Engine” and start the engine.
2. Release your foot from the acceleration pedal (6) and change
the engine speed to idling.
3. Check the number on the operation plate at the switches on the
outrigger operation panel to determine which outrigger to be
operated.
4. Push down an outrigger extension switch or two of them at the
same time to the “OUT” side.
When the outrigger extension cylinder extends and the inner box
extends to the desired position, set the switch to the “NEUTRAL”
position.
Operate the remaining switches in the same way and extend the
inner box of the four outriggers to the desired position. Set the
switch to the “NEUTRAL” position.
5. Push down an outrigger setting switch or two of them at the
same time to the “OUT” (downward) side.
When the setting cylinder extends and the tray is set, set the
switch to the “NEUTRAL” position.
Operate the remaining switches in the same way and set the tray
of all the four outriggers. Set the switch to the “NEUTRAL”
position.
To Next Page
Loading...
