3-97
2. See “Operation 2.2 Starting Engine” and start the engine.
3. Release your foot from the acceleration pedal (6) and change
the engine speed to idling.
4. Operate the work selector switch on the outrigger operation
panel to the “OUTRIGGER” position.
5. Verify that the boom stowing lamp (1) (green) on the outrigger
display is illuminated.
When operating two outrigger setting switches at the same time, choose two front switches
(outrigger (1) and (4)) or two rear switches (outrigger (2) and (3)). Operating two left or right
switches at the same time will suddenly raise two outriggers on one side, causing overturning
of the machine.
6. Check the number on the operation plate at the switch section
on the outrigger operation panel to determine which outrigger to
be operated.
7. Push down an outrigger setting switch or two of them at the
same time to the “ON” (upward) side.
When the outrigger setting cylinder retracts and the machine
starts to go down, return the switch to the “NEUTRAL” position.
Operate the remaining switches in the same way and lower all
the four outriggers to the same height. Return the switch to the
“NEUTRAL” position.
Repeat this operation to gradually lower the machine until the
rubber tracks go down completely on the ground.
8. When the left and right rubber tracks are completely set on the
ground, push down again an outrigger setting switch or two of
them at the same time to the “IN” (upward) side.
When the setting cylinder completely retracts and the top box
goes up to the upper limit, release your finger from the outrigger
setting switch.
To Next Page
