Mazda 121 - Page 140

OIL
PUMP
Removal
Note
A/C compressor
(with
A/C)
Caution
.
Do
not damage
the
hoses.
1 . Remove the A,/C compressor
with
the hoses still connected.
2. Position the compressor
away trom ihe
engine and afiix
it
with
wire.
Sleps
After Insiallation
1. Install the oil
pan
and main bearing
support
plate
(Reler
to
page
D-8.)
2. Install the
timing belt.
(Refer
to Section
B.)
3. Fill with the specified
amount
and type
of engine oil.
(Refer
to
page
D-5.)
4. Connect the
negative battery cable.
5. Start the engine and
check lor leaks.
6. Check the oil level and add
oil if necessary.
orAooxol3
D-10