Mazda 121 - Page 367

TRANSAXLE
J
@t@
@
Note
.
Procedure work with a
pull
scale.
.
Procedure 12 work wilh
a
torque wnench.
11. Turn the
SST
with a
pull
scale.
Adjusi the
SST
(preload
adapter)
until
the specified
preload.
Preload: 0.5--0.7 N.m
(5-7.6
cm-kg, 4.3-6.6 inlb)
Puff scafe:500-760
g
(17.7-26.8
ozl
12. Turnthe SST with
atorquewrench.
Adjust the SST
(selec-
lor)
with the
bars until the
specified
preload
is obtained.
Preload: 0.5-0.7 N.m
(5-7.6
cm-kg, 4.3-6.6 In-lb)
13. Bemove the SST.
14.
Measure the
gap
around
the
entire circumference
of the
SST
(seleqtor).
15. Select the
proper
adjustment shim(s) to be used
for the
ditferential by referring to the table and selecting the shim
which is nearest
(onthethick
side) to the largest measured
clearance
in the selector.
Adiustment
shim lhickness:
16.
Remove the SST
(bolts).
17. Remove the
transaxle
case and
the
SST
(collars).
'18.
Remove the bearing outer race from the SST
(selector).
Install the selected shim(s) and
transaxle
case.
bearing outer race to
the
't9
0-25
(0.010)
0.10
(0.004)
0.35
(0.014)
0.80
(0.031)
J-43