McHale Fusion 2 specific section
05-1
McHale Fusion 2 round baler wrapper technical service manual
Issue 1: 0208
5. Specific safety warnings
5.1 Electronic safety warnings
¾ This machine is equipped with electronic parts and components which comply
to the EMC directive 89/336/EEC but still may be influenced by
electromagnetic transmissions of other apparatus, such as welding machines,
etc.
¾ Check electric cables regularly for signs of breakage or wear. If in doubt
always replace (faulty safety circuits will cause risks).
¾ Do not modify any safety circuits.
5.2 Hydraulic safety warnings
¾ The maximum pressure in the hydraulic system of this machine should not
exceed 210 bar.
¾ Always ensure system is not under pressure before working on the machine.
Oil under pressure can penetrate the skin and cause injury. Beware of pipes
under accumulator pressure, depressurise lines by unthreading connections
extremely slowly.
¾ Hydraulically actuated devices, such as pick-up, cutting device and wrapping
ring, must be blocked mechanically against movement, before working on the
machine.
¾ If any hoses are removed or replaced ensure they are marked and re-installed
to the correct position during re-assembly.
¾ Check hoses regularly for signs of leakage or wear. If in doubt always
replace – the recommended maximum working time of hoses should not
exceed 5 years. Only use exact specification, McHale genuine replacement
parts.
¾ Do not work on hydraulic systems unless you are qualified to do so, this work
should only be carried out by qualified persons or your McHale dealer.
To Next Page
Loading...
