McHale Fusion 2 maintenance section
10-1
McHale Fusion 2 round baler wrapper technical service manual
Issue 1: 0208
10. Machine maintenance
To maintain the McHale
Fusion 2
in good working order it is necessary to carry out
preventative maintenance regularly. The following section outlines areas to be
checked and recommends when certain components should be replaced.
Caution: It is vitally important to observe health and safety rules at all times to
avoid unnecessary environmental damage or danger to anybody near the
machine. This especially applies to the responsible disposal of oil, etc.
10.1 Maintenance intervals
The following section provides a list of areas which can checked during an end of
year service or after a pre-determined number of bales.
It is important to note that this section provides guidelines which trained service
personnel can follow. Other service issues may need to be taken into consideration
due to crop and ground conditions in the country in question.
Warning!
Ensure to wear proper safety equipment at all times when working with the
machine, such as gloves, eye protection etc. and follow all safety decals and
instructions as stated in this manual.
McHale recommend that nobody ever be in the danger zone (for additional
information on the danger zone please refer to section 4.9) at any time during
machine operation, but in the event of carrying out inspections (contrary to
our safety recommendations) when the machine is in operation, there must
always be a second operator at the tractor controls (who is fully competent in
the operation of both the tractor and the machine) in case of emergency stop
action is required.
To Next Page
Loading...
