McHale Fusion 2 - Chopper Unit Duplex Chain Adjustment

McHale Fusion 2 maintenance section
10-25
McHale Fusion 2 round baler wrapper technical service manual
Issue 1: 0208
10.6.7: Chopper unit duplex chain adjustment
To adjust the duplex chain the following tools are required; two 24mm span-
ners. Follow the below procedure:
1. Using the 24mm tools, loosen nyloc nut (A).
2. Tighten nut (B) until the distance from the bottom of the rubber spring (c)
to the top of the washer under the nut (B) is 75mm.
3. Hold nut (B) with one spanner and tighten nut (A) down onto nut (B) with
the second spanner.
A
B
C