McHale Fusion 2 requirements & preparation section
07-6
McHale Fusion 2 round baler wrapper technical service manual
Issue 1: 0208
9. Remove knives with a pair of pliers.
10. Replace with knife blanks to prevent crop catching in the slots, these are
stored in the knife/ knife blank holster which is located in the front left
compartment of the Fusion 2.
Warning! Always keep this compartment door panel closed while the machine
is running, danger of rotating components! Note the warning decals and
ensure that all safety measures and precautions are carried out before
attempting to carry out any maintenance.
Warning! Do not forget to turn the levers back into the working position, but only
after having finished all work in the baler as shown above.
11. To replace knives remove knife blanks and follow the above procedure,
heeding all decal warnings and safety procedures.
To Next Page
Loading...
