2. Remove the cables and pulley from the cable case.
3.
Inspect the pulley for cracks. Inspect the cables for kinks, frayed or broken cables. Ensure that the cables slide freely in the
outer jacket.
4. If any defects are found, replace the component.
a - Cable case
b - Pulley
c - Cover
d - Cables
e - Screw and washer
Assembly
1.
Install the cable end barrel into the slot on the pulley.
a - Throttle cable
b - Cable end barrel in slot
c - Pulley
2. Apply 2‑4‑C with PTFE to the throttle cable end barrels, the face of the pulley, and the outer diameter of the pulley.
Tube Ref No. Description Where Used Part No.
95
2-4-C with PTFE Throttle cable end barrels, pulley face, and pulley O.D. 92-802859A 1
3. Install the pulley with the cables into the case.
a
b
c
e
3008
d
a
a
b
b
c
3009
Tiller Handle
Page 7B-12 © 2018 Mercury Marine 90-8M0125265 eng NOVEMBER 2017
To Next Page
Loading...
Need help?
General