Microplex logiJET T4-2 - Page 170

170 Using the RFID Functions
_______________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX Operator’s Manual logiJET T4-2 /T6-2 /RFID Edition 2.2
Panel display
Explanations, Remedies
[RFID Error ]
[DataReadTimeOut ]
or
[RFID Error ]
[DataWriteTimeOut ]
An RFID command (read, program, etc.) has
failed to complete in the maximum amount of
allowed time.
- increase the number of retries *
See section 10.2.4 Adjusting the Number of
RFID Access.
- make sure the media has been
loaded correctly
(compare section 5.2)
- if you made supply or print position settings,
make sure the RFID tag was set to the right
position
- see section 10.2.3 Adjusting the Transponder
Position (Tag Position), too.
* Note: The RFID printer pauses while
programming the RFID tag
Mantenimiento Periféricos Informáticos C/Canteras, 15 28860 Paracuellos de Jarama (Madrid) Tel: 00 34 917481604 Web: https://mpi.com.es/