Minebea CSD-814B - 9−7. Power Supply Voltage AC200 V(CSD814 B−P63); 9−7−1. Layout of Terminals

130
9−7. Power supply voltage AC200 V(CSD814B−P63)
9−7−1.
Layout of terminals
2 pieces of terminals on which 16 places of terminal points are prepared on the rear panel of the
instrument. Layout of terminals whose power supply voltage specifies AC200 V shall be shown
in the below table.
Terminal No. Name Application Terminal No. Name Application
① ZERO ⑰ A
② A/Z ⑱ F
③ A/Z OFF
External
⑲ G
Strain
gage
④ HOLD
External
control
input
⑳ C
Strain
gage
applied
transducer
⑤ LOCK
control
input
D
transducer
terminal
s
⑥ A−SEL
terminal
s
B
terminal
⑦ COM.1
terminal
E
side
terminal
⑧ F.G.
Frame ground
side
terminal
A.G.
Analog ground
side
⑨ RUN
side
N.C.
Upper
side
⑩ S0
Lower
side
N.C.
Not
used.
Upper
⑪ S1
Lower
N.C.
Not
used.
Upper
⑫ S2
Contact
output
Lower
N.C.
⑬ S3
Contact
output
F.G.
Frame ground
⑭ S4 GND
Supply
power
⑮ ERROR AC
Supply power
source.
⑯ COM.2 AC
source.
● Between COM.1(Terminal No.7) and COM. 2(Terminal No.16) is
isolated.
● Refer to the paragraph 4−2, as for application note on connection.
● Supply voltage is AC200 V (AC170 V to AC264 V), 50/60 Hz