35
6−3−4.
Operation is made in another mode.
(1)
Digit down for set value
When the key is pressed with the condition of displaying various kinds of set values, the
digit of set value is down towards the digit of 10
0
of set value one by one.
(2)
Changeover of function and so on.
Changeover(return) of various kinds of functions in Function mode and also change over
(return) of function in Check mode can be made.
● In the operation in the paragraph 6−3−3. and 6−3−4., when the key
is pressed for more than 2 s, each key operation will be executed
continuously at a constant interval without the operation of ON/OFF.
6−4. key
6−4−1.
Single key is pressed in Measurement mode.
10
0
digit at set value of comparator S3 will flash, then setting for set value of comparator S3
will be possible. Moreover, if any key operation is not made during 20 s approximately, that is,
untouched, the mode will be returned to the measurement mode automatically.
By pressing the key, changed set value will be registered internally, the condition of
available setting for S3 can be closed.
6−4−2.
When pressed with the key together in Measurement mode.
When the display value on load display is within 10 % against maximum display value (Refer to
the section 5.), zero set function will activate and then make the display “0” compulsively. As for
details, refer to the paragraph 7−9.
6−4−3.
When operated in fine adjustment mode for ZERO and SPAN.
“UP” operation of fine adjustment for ZERO and SPAN can be made.
6−4−4.
When operation is made in the other mode.
(1)
Increment of set value
When the key is pressed with the condition of displaying various kinds of set value, set
value will increase at one increment, such as 0, 1, 2, 3, 4, 5, 6, 7, 8, 9, and 0, one by one.
● In the operation in the paragraph 6−4−3. and 6−4−4, when the key
is pressed for more than 2 s, each key operation will be executed
continuously at a constant interval without the operation of ON/OFF.
To Next Page
Loading...
Need help?
General
