V
2. Power supply
● Before supplying the power, check that the indication of power
supply/specification for the instrument and the power going to supply
should be the same. If they are not equal, contact with Minebea.
If you use the instrument without checking them, it may cause a
damage in the instrument or electric shock to the operator.
Warning ● In order to prevent from a damage to the instrument and electric
shock to the operator, be sure to check that power supply is off when
installing each cable.
● Earth wire should be grounded securely. When earth wire is not
connected, it may cause a malfunction of the instrument or electric
shock to the operator.
3. Application Notes
Warning ● Before using a new instrument or exchanging the strain gage applied
transducer for a new one, be sure to make calibration.
If calibration shall not be made, correct measured results may not be
obtained nor which may cause malfunction in the instrument and
there may exist damage in peripheral equipments.
Besides, even though calibration has been made, there may occur the
similar case when the result is not correct, so make calibration again.
Warning ● In case of using the instrument, check that the connections are
executed properly. If not connected properly, correct measured result
will not be obtained, nor it may cause malfunctions of the instrument,
damage to the peripheral equipments or even more serious accident.
Warning ● When change of setting is made carelessly on the instrument during
measurement, it may cause malfunction in the instrument and also
possibilities of damage in peripheral instruments.
To Next Page
Loading...
Need help?
General
