33
6.
Operating Procedures
We’ll show the operating procedures for the instrument with each key located on the front panel.
Warning ● Operation with each key should be made after interrupting the
measurement. If it is made during measurement, it may cause an
unexpected malfunction.
● Key operation during Measurement mode can be effective by pressing
for about 1 s or so.
6−1. key
6−1−1.
When pressed with another key together simultaneously in Measurement mode.
By pressing with each key together, shift function for each key will be effective.
6−1−2.
Pressed with the condition of available setting for comparator S1, S2, S3, and S4.
When S1, S2, S3, and S4 are pressed with the condition of available setting, the target for set
value to be set will change S1 → S3 → S3 → S4 → S1 ･･･.
● In the operation of the paragraph 6−1−2., when the key is pressed
for more than 2 s, each key operation will be executed continuously at
a constant interval without the operation of ON/OFF.
6−2. key
6−2−1.
Single key is pressed in Measurement mode.
10
0
digit at set value of comparator S1 will flash, then setting for set value of comparator S1 will
be possible.
Moreover, if any key operation is not made during 20 s approximately, that is, untouched, the
mode will be returned to the measurement mode automatically.
By pressing the key, changed set value will be registered internally, the condition of
available setting for S1 can be closed.
6−2−2.
When pressed with the key together in Measurement mode.
At the same time, when tare cancellation (A/Z) function will activate and load display value
becomes net weight display value, “A/Z” on status display will be “0”.
6−2−3.
When operated in fine adjustment mode for Zero and Span.
“Down” operation of coarse adjustment for ZERO and SPAN can be made.
To Next Page
Loading...
Need help?
General
