34
6−2−4.
When operation is made in another mode.
(1)
Carrying set value
When the key is pressed with the condition of displaying various kinds of set values, the
flashing digit for set value will carry from 10
0
to 10
1
, 10
2
, 10
3
, 10
04
, and 10
5
one by one.
(However, the range of carry will differ depending to the number of set value and yes/no of
polarity.)
(2)
Changeover of function and so on.
Changeover of various kinds of functions in Function mode, changeover of function in Check
mode can be made as well.
● In the operation in the paragraph 6−2−3. and 6−2−4., when the key
is pressed for more than 2 s, each key operation will be executed
continuously at a constant interval without the operation of ON/OFF.
6−3. key
6−3−1.
Single key is pressed in Measurement mode.
10
0
digit at set vale of comparator S2 will flash, then setting for set value of comparator S2 will
be possible.
Moreover, if any key operation is not made during 20 s approximately, that is, untouched, the
mode will be returned to the measurement mode automatically.
By pressing the key, changed set value will be registered internally, the condition of
available setting for S2 can be closed.
6−3−2.
When pressed with the key together in Measurement mode.
Only when tare cancellation (A/Z) function activates, release of tare cancellation (A/Z off)
function will activate, at the same time that load display value will become gross weight display
value, “A/Z” on status display will put off.
6−3−3.
When operated in fine adjustment mode for ZERO and SPAN.
“UP” operation of coarse adjustment for ZERO and SPAN can be made.
To Next Page
Loading...
Need help?
General
