MIR 1350 - Connecting to Robot Interface

6. Getting started
MiR1350 User Guide (en) 05/2022 - v.1.2 ©Copyright 2021-2022: Mobile Industrial Robots A/S. 60
3. Press the Resume button to clear the Protective stop.
The robot is now ready for operation.
If you are not able to power up the robot upon delivery, see
MiR48VBattery Technical Guide to troubleshoot the issue.
6.5 Connecting to the robot interface
When the robot is turned on, you can connect a PC, tablet, or phone to the
robot's internal network via the RJ45 Ethernet port under the bumper on the
front-right corner shield of the robot. Once connected, you can configure the
robot's settings and connect it to a wireless network.
You can connect to the robot using an Ethernet cable or an access point. If you
are located in North America, EU, or a part of EAC, you can purchase a
MiRAccessPoint from MiR. Outside these areas, you need to use your own