6. Getting started
MiR1350 User Guide (en) 05/2022 - v.1.2 ©Copyright 2021-2022: Mobile Industrial Robots A/S. 63
You are now signed in to the robot interface and can set up your robot for
operation.
If you want to connect the robot to your local WiFi network, connect the robot to
the network as described in Connecting the robot to a WiFi network on the
next page.
If you want to drive the robot off the pallet immediately, you can do so from the
interface as described in Driving the robot in Manual mode on page68.
If you are going to drive the robot manually and you are using an
Ethernet cable to connect to the robot, make sure that the cable you
have used is long enough for the robot to move without
disconnecting the cable.
Always make sure your robot is running the latest recommended
software. This also applies to newly supplied robots, as there may
have been important software updates during the storage time and
shipment of the robot. Contact your distributor for the latest
recommended update file.
To Next Page
Loading...
