2. CNC Monitor Screen
2.5 Program
I - 113
After completion of correction,
press the [INPUT] key.
1) The new data is written into memory.
2) The new data is also displayed with each word
being both preceded and followed by space.
3) The cursor is moved to the top of the block
corrected on the screen.
4) When the data has been written into memory,
the EDITING message disappears. The editing
state turns “EDIT (REP.)”
(4)
EDIT (REP.)
N1 G28 X0 Y0 Z0;
:
N7 G03 Y200. J100. F5000 ;
M02;
%
To Next Page
Loading...
