2. CNC Monitor Screen
2.5 Program
I - 130
[Program display]
When the menu key [PROGRAM] is pressed, the searched program appears on the left side of the screen,
and a list of programs registered in the memory appears on the right side of the screen. The operation
search menu (COM.SRH) is highlighted, and the setting area is displayed.
Display items Contents
O12345678 Display the searched program No.
G28 XYZ;
G28ABC;
.
.
.
Display the searched program.
PROGRAM ENTRY
and REMAIN
The No. of programs already registered as userd machining programs appears in the
PROGRAM ENTRY column. The remaining No. of programs that can be registered
appears in the REMAIN column.
The total of "PROGRAM ENTRY" and "REMAIN" is the maximum No. of programs.
This figure is determined by the specifications.
CHARACTER and
REMAIN
The No. of characters already registered as user machining programs appears in the
CHARACTER column. The remaining No. of characters that can be registered
appears in the REMAIN column.
The value in the REMAIN column is displayed in 250-character units.
<PROGRAM> This item shows the Nos. of the machining programs already registered. The Nos. are
displayed in order from the smallest No.
The display range is from 1 to 99999999 and displayed in ascending order.
<CHR> This item shows the No. of characters registered in the memory for the corresponding
machining program No
<ST> Not used.
<COMMENT> An outline of the machining program functions, specifications, applications, etc., can
be displayed as a comment in this item.
The comment can be set with up to 18 alphanumeric or symbol characters.
To Next Page
Loading...
Need help?
General
