2. CNC Monitor Screen
2.5 Program
I - 133
[Operation search]
Calling a program
The program Nos., sequence Nos., and block Nos. for executing automatic operation can be called from
the machining programs registered in the memory.
(1) Press the menu [COM.SRH].
The setting area for "COM.SRH" will be
displayed.
O( ) N( )-( )
COM.SRH
(2) Set the program No. to be called. Set the
sequence No. and block No. if neccessary.
(Example)
O( 1112) N( 15)
－
( )
O( 1112) N( 15)-( )
COM.SRH
(3) Press [INPUT].
(a) Start the search.
(b) The program No. is displayed if the
designated program No., sequence No.
or block No. is found, and goes back to
the word edit screen (the first menu).
SEARCH EXECUTION
O( 1112) N( 15)-( )
COM.SRH
(Note 1) A program will be deleted if the program No. is entered and [C.B] is pressed when the setting
area is displayed.
To Next Page
Loading...
