Mitsubishi FX3U-20SSC-H - Page 108

7 Before Starting Positioning Operation
102
FX3U-20SSC-H Positioning Block User's Manual
7.6 Changing During Operation (Operation Speed, Target Address)
From the previous page From the previous page
M373
Setting the target address change command in positioning operation (Y-axis) to ON
SET D273.E
D273 U1\G618
FNC 12
MOV
SET M375
Reads the operation
command 1 (Y-axis) in
unit No. 1.
Sets the target position
change command in
positioning operation
(Y-axis) in unit No. 1.
Sets (writes) the operation
command 1 (Y-axis) in
unit No. 1.
U1\G618 D273
FNC 12
MOV
Disabling the change command in operation (X-axis)
M374 D270.E
SET D272.C
U1\G518 D272
FNC 12
MOV
RST D272.E
D272 U1\G518
FNC 12
MOV
Reads the operation
command 1 (X-axis) in
unit No. 1.
Sets the change command
in operation disabled
(X-axis) in unit No. 1.
Resets the target position
change command in
positioning operation
(X-axis) in unit No. 1.
Sets (writes) the operation
command 1 (X-axis) in
unit No. 1.
Disabling the change command in operation (Y-axis)
M375 D271.E
SET D273.C
U1\G618 D273
FNC 12
MOV
RST D273.E
D273 U1\G618
FNC 12
MOV
Reads the operation
command 1 (Y-axis) in
unit No. 1.
Sets the change command
in operation disabled
(Y-axis) in unit No. 1.
Resets the target position
change command in
positioning operation
(Y-axis) in unit No. 1.
Sets (writes) the operation
command 1 (Y-axis) in
unit No. 1.
SET M376
SET M377
M376 M377
M370 M377
FNC 40
ZRST
END
D270 D273
FNC 40
ZRST
M372
Setting the target address change command in positioning operation (X-axis) to ON
SET D272.E
D272 U1\G518
FNC 12
MOV
SET M374
Reads the operation
command 1 (X-axis) in
unit No. 1.
Sets the target position
change command in
positioning operation
(X-axis) in unit No. 1.
Sets (writes) the operation
command 1 (X-axis) in
unit No. 1.
U1\G518 D272
FNC 12
MOV