Mitsubishi FX3U-20SSC-H User Manual

7 Before Starting Positioning Operation
72
FX3U-20SSC-H Positioning Block User's Manual
7.1 Note on Setting Parameters
From the previous page From the previous page
M322
U1\G132 D225
FNC 12
MOV
D223 U1\G619
FNC 12
MOV
Reads the status information
2 (Y-axis) in unit No. 1.
Reads the operation
command 2 (Y-axis) in
unit No. 1.
Resets the positioning
parameter enable command
(Y-axis) in unit No. 1.
RST D223.4
Sets (writes) the operation
command 2 (Y-axis) in
unit No. 1.
RST M322
D225.0
U1\G619 D223
FNC 12
MOV
Positioning
parameter
change
completion
flag (Y-axis)
(Ver. 1.20
or later)
Setting the positioning parameter enable command to OFF (Y-axis)
* Set this command to OFF after one operation cycle when the version is earlier than 1.20.
M320
M323
M320 M324
FNC 40
ZRST
END
D220 D225
FNC 40
ZRST
M321
SET M323
M320 M322
SET M324
M324

Mitsubishi FX3U-20SSC-H Specifications

General

Brand	Mitsubishi
Model	FX3U-20SSC-H
Category	Controller
Language	English