5 - 76
No. 99MBB091A
5
<Tilt Compensation P1 Input screen>
7
<Tilt Compensation P2 Input screen>
6
<Tilt Compensation Arbitrary Setting
Input screen>
TiltCompensation
P1
4 5 6
7BS
AC
8 9
1 2
0
3
ESC
mm
0.00
.
(0.00 99.99mm)
TiltCompensation
P2
4 5 6
7BS
AC
8 9
1 2
0
3
ESC
mm
0.00
.
(0.00 99.99mm)
Tilt compensation
mm
mm
mm
mm
P3
P4
0.00
P2 9.00
9.00
P1 0.00
ESC
P1 P2 P3 P4
P1 P2 P3 P4
P1 P2 P3 P4
Enter the 1st point in the tilt compensation range in the Tilt
Compensation P1 Input field, and then touch the [Enter] key.
The P1 enterable range is as shown below.
0.00 to 99.99mm (in the units of 0.01mm)
TIP • When the P1 value is set to 0.00mm, the
beginning of a measured profile becomes the
start point of the tilt compensation range.
• For information about how to enter a numeric
value, refer to “2.2 Outline of the Touch
Panel ■ Inputting numeric values”.
The Tilt Compensation Arbitrary Setting Input screen is
restored.
Touch the [P2] button.
The Tilt Compensation P1 Input screen will appear.
Enter the 2nd point in the tilt compensation range in the Tilt
Compensation P2 Input field, and then touch the [Enter] key.
The P2 enterable range is as shown below.
0.00 to 99.99mm (in the units of 0.01mm) as tilt compensa-
tion setting
NOTE The P2 value must not be less than the P1
value.
TIP • If the P2 value is larger than the evaluation
length, the end of a measured profile be-
comes the end point of tilt compensation.
• For information about how to enter a numeric
value, refer to “2.2 Outline of the Touch
Panel ■ Inputting numeric values”.
The Tilt Compensation Input screen is restored.
To Next Page
Loading...
