Mitutoyo SJ-301 - Page 175

5 - 77 No. 99MBB091A
5. MODIFYING THE MEASUREMENT CONDITIONS
10
<Tilt Compensation Arbitrary Setting
Input screen>
9
<Tilt Compensation P3 Input screen>
8
<Tilt Compensation Arbitrary Setting
Input screen>
TiltCompensation
P3
4 5 6
7BS
AC
8 9
1 2
0
3
ESC
mm
0.00
.
(0.00 99.99mm)
Tilt compensation
mm
mm
mm
mm
P3
P4
0.00
P2 9.00
9.00
P1 0.00
ESC
P1 P2 P3 P4
P1 P2 P3 P4
P1 P2 P3 P4
Tilt compensation
mm
mm
mm
mm
P3
P4
0.00
P2 9.00
9.00
P1 0.00
ESC
P1 P2 P3 P4
P1 P2 P3 P4
P1 P2 P3 P4
Advance to step 9 if tilt compensation is performed in two
sections, and advance to step 13 if it is not performed in two
sections.
Touch the [P3] button.
The Tilt Compensation P3 Input screen will appear.
Enter the 3rd point in the tilt compensation range in the Tilt
Compensation P3 Input field, and then touch the [Enter] key.
The P3 enterable range is as shown below.
0.00 to 99.99mm (in the units of 0.01mm) as tilt compensa-
tion setting
NOTE The P3 value must not be less than the P2
value.
TIP For information about how to enter a numeric
value, refer to “2.2 Outline of the Touch Panel
■ Inputting numeric values”.
The Tilt Compensation Input screen is restored.
Touch the [P4] button.
The Tilt Compensation P4 Input screen will appear.