MOOR INSTRUMENTS moorLDI2 RESEARCH USER MANUAL
9
1.5 ELECTRICAL SAFETY LABELS
Location: Control box rear panel
Locations: Scan head rear panel adjacent to video connector.
Meaning: General Warning! The computer must be compliant with IEC 950 and
be configured to comply with IEC 60601-1. Do not touch the patient and parts of
either the connecting leads or mating sockets at the same time.
Locations: Control box rear panel adjacent to video connector.
Meaning: Caution! Non-isolated outputs (e.g. BNC output for devices such as
MIC2, and RS-232 / Firewire connections). The computer must be compliant
with IEC 950 and be configured to comply with IEC 60601-1. Do not touch the
patient and parts of either the connecting leads or mating sockets at the same
time.
Location: Rear panel of control box and scan head.
Meaning: This is to indicate that the equipment is of Type B as defined by IEC
60601-1, and has no applied parts which are intended to come into contact with
the patient.
Locations: Control box rear panel and scan head real panel
Meaning: Refer to operating instruction before connecting the scan head to the
control box.
Locations: Control box rear panel and scanner head real panel
Meaning: The marking of a product with the CE mark is intended to confirm
that the product meets all of the essential Health & Safety Requirements
contained in the relevant EU directive.
Locations: Control box rear panel
(See Section 26 Disposal)
WARNING
ISOLATE MACHINE BEFORE REMOVING COVERS
ATTENTION
ISOLER MACHINE AVANT D'ENLEVER COUVERCLES
ACHTUNG
MASCINE ISOLIEREN BEVOR ENTFERNUNG DER DECKEL
AVISO
AISLE LA MAQUINA ANTES DE QUITAR
ATTENZIONE
ISOLARE MACCHINA PRIMA DI RIMOUVER COPERCHI
!
0120
To Next Page
Loading...