Moor Instruments moorLDI2-VR - BASIC STAND (Moorldi-BS1); DESKTOP STAND (Moorldi-DS2)

MOOR INSTRUMENTS moorLDI2 RESEARCH USER MANUAL
16
The Transverse Arm
This passes through the winder box. First remove the handle from the transverse arm and loosen the
knobs on the side of the winder box. Pass the transverse arm, from the front, through the winder box
(the longest forks of the H frame are at the front).
This part joins to the front of the vertical slide assembly on the vertical column.
The Yoke and Scan Head
The yoke is attached to the scan head at the side bearings: 4 bolts each. Recent models have a central
screw to secure these components. Take care to include all parts of the bearing including O ring and
pressure plate. Recent models incorporate a central holding screw.
Replace clamp handle and tighten with scan head mounting plate horizontal.
The yoke is then attached to the transverse arm via the top bearing.
The moorLDI-THB
The transformer housing box (THB) also contains the moorLDI2 control box and cable management.
The THB is attached to the back of the H frame: two lugs at the rear and one at the front.
Assembly
After checking all necessary parts are present and before cable connection, assemble the stand, using
the supplementary guide provided.
3.1.2 BASIC STAND (moorLDI-BS1)
Components for the basic stand are packed separately. Unpack these components and assemble
according to supplementary instructions provided.
3.1.3 DESKTOP STAND (moorLDI-DS2)
Components for the desktop stand are shipped separately in a cardboard carton. Remove these
components from the carton and assemble according to supplementary instructions provided.