Moor Instruments moorLDI2-VR - Unpacking the Scan Head; Installation of F6 C Framegrabber Card (Analogue Camera Model)

MOOR INSTRUMENTS moorLDI2 RESEARCH USER MANUAL
17
3.2 UNPACKING THE SCAN HEAD
The moorLDI2 is shipped in the blue plastic transport case. This case contains two layers.
The top layer contains the following:
Analogue Camera Model:
1 off moorLDI2 controller
1 off moorLDI2 8-way scan head-to-controller cable (Basic stand and Desktop stand only)
1 off moorLDI2 25-way scan head-to-controller cable (Basic stand and Desktop stand only)
1 off moorLDI2 scan head-to-PPC framegrabber video cable
1 off framegrabber card (if a PPC Kit was supplied by Moor Instruments, the framegrabber card will
already be installed and tested in the PC supplied)
1 off computer-to-controller serial cable
1 off mains electricity lead
1 off set of software installation discs/CD
Firewire Camera Model:
1 off moorLDI2 controller
1 off moorLDI2 8-way scan head-to-controller cable (Basic stand and Desktop stand only)
1 off moorLDI2 25-way scan head-to-controller cable (Basic stand and Desktop stand only)
1 off moorLDI2 scan head-to-controller video cable
1 off Firewire Interface Card (if a PPC Kit was supplied by Moor Instruments, the Firewire Interface
card will already be installed and tested in the PC supplied)
1 off computer-to-controller serial cable
1 off IEEE 1394 Firewire cable
1 off mains electricity lead
1 off set of software installation discs/CD
The lower layer contains the scan head. Remove this carefully and attach it to the stand supplied
(refer to supplementary instructions).
3.3 INSTALLATION OF F6C FRAMEGRABBER CARD (ANALOGUE CAMERA
MODEL)
Note: if you are using a laptop computer with a docking station, the framegrabber card is
installed within the docking station. If a docking station is not used, the video signal will not be
available.
To install the card follow these steps:
1. Switch off your computer and all peripheral devices.
2. Remove the cover from your PC.
3. Discharge yourself of electrostatic charge: with the PC power cable plugged in the wall
socket but not switched on, discharge yourself of electrostatic charge by touching the metal
case of your computer.