Moor Instruments moorLDI2-VR - Installation of Firewire Card (Firewire Camera Model)

To Next Page

To Previous Page

MOOR INSTRUMENTS moorLDI2 RESEARCH USER MANUAL

4. Select a free PCI slot and remove the external cover.

5. Insert the framegrabber card carefully in the selected PCI slot.

6. Replace the cover of your PC.

Connect the video cable from the camera to the framegrabber card.

3.4 INSTALLATION OF FIREWIRE CARD (FIREWIRE CAMERA MODEL)

Please note not all laptop computers with Firewire interface work with the Firewire camera,

therefore only a laptop supplied by Moor Instruments can be guaranteed to work.

To install the card in a desktop or panel PC follow these steps:

1. Switch off your computer and all peripheral devices.

2. Remove the cover from your PC.

3. Discharge yourself of electrostatic charge: with the PC power cable plugged in the wall

socket but not switched on, discharge yourself of electrostatic charge by touching the metal

case of your computer.

4. Select a free PCI slot and remove the external cover.

5. Insert the Firewire interface card carefully in the selected slot.

Replace the cover of your PC.

Connect the video cable from the scan head to control box, but do not connect the Firewire

cable from the control box to the Firewire interface card at this stage.