MOOR INSTRUMENTS moorLDI2 RESEARCH USER MANUAL
53
Select this option to delete the temporary files (saved in the C: root directory) when the
corresponding measurement window is closed.
Show Repeat Interval Confirmation Message at the Beginning of Repeat Scan:
Select this option to enable the warning message when the selected interval is shorter than the
estimated scan (one image) time.
Turn Off Solenoid during Repeat Scan Interval (End to Begin) is longer Than 30 Seconds:
Select this option to attenuate the laser (turn the solenoid off) during repeat scan intervals (if the
interval from the end of one scan to the start of the next one is longer than 30 seconds). Otherwise,
the the laser will remain at full power (solenoid not turned off) during repeat intervals.
Capture and Save the First Video Image Only (if camera is on) for Repeat Scan:
Select this option to capture and save only one video/CCD image at the start of a repeat scan,
otherwise a video image will be captured at the start of every repeat scan image (note: capturing a
video image at the start of every repeat scan image will take significant harddisk/memory, therefore it
is not recommended unless absolutely necessary).
Enable Iontophoresis Functions:
If iontophoresis hardware is available, select this option will enable all iontophoresis related
functions. Measured voltage V1 (at the start of an image scan) and V2 (at the end of an image scan)
will be displayed just below each Flux image.
To Next Page
Loading...