141
机床操作面板
MACHINE OPERATION PANEL
自动运行按钮 [ 暂停 ] Automatic Operation Button [STOP]
此按钮用于在自动运行期间临时停止轴的运动。 This button is used to temporarily stop axis movement during
automatic operation.
执行试切或程序检查时，操作员必须做好出现问题时立即按下
此按钮的准备。
When a test cutting or program check is carried out, the
operator must be ready to press this button immediately if a
problem arises.
2-4 数控功能按钮
NC Function Buttons
数控功能按钮用于以下用途。 The NC Function buttons are used for the following purposes.
1. 在自动模式下检查程序和执行试切 1. To check programs and carry out test machining in the
automatic mode
2. 用手动操作中断自动运行模式下执行的操作 2. To interrupt operation being carried out in automatic
operation mode with a manual operation
确保执行程序检查或试切前完全理解以下讲述的数控功能。 Make sure you thoroughly understand the NC functions
explained below before carrying out program checking or test
cutting.
2 注意 2 NOTE
1. 操作选择钥匙开关置于
u
[ 不可操作 ] 位置时，这些按钮无效。 1. These buttons are not operative when the operation selection
key-switch is placed in
u
[OFF] position.
2. 即使电源关闭，
x
[ 可选停止 ] 按钮和
c
[ 节删除 ] 按钮仍然有效。 2. The
x
[OSP] (Optional Stop) button, and the
c
[BDT] (Block
Delete) button remain set even if the power is turned off.
3. 通过使用按钮或在‘ 操作面板 ’屏幕上进行设置，可将数控功能置为
有效或无效。
3. The NC functions are made valid or invalid either by using the
buttons or by making settings on the ‘ OPERATION PANEL’
screen.
1 “‘ 操作面板 ’屏幕 ” （ 208 页） 1 “‘ OPERATION PANEL ’ Screen” (page 208)
FUNCTION
OSP BDT
DRN PCK
To Next Page
Loading...