Motion Control Engineering 2000

7-1
7
• In this Section
• Parameter Settings Record
• Elevator Security Information
• LS-QUTE Assembly
In this Section
• Motion 2000 Parameter Settings Record: Use this table to record the original
parameter values and any changes made to these values (see page 7-2).
• F7 Parameter Settings Record: Use this table to record the original parameter values
and any changes made to these values (see page 7-10)
• Elevator Security Information and Operation: Use this form to record information
about building security and the programmed security codes. This form may given to build-
ing tenants (see page 7-12).
• LS-QUTE landing System Assembly Drawings: Assembly and wiring drawings for
the LS-QUTE Landing System (see page 7-14).
• ICE-COP-2 I/O Assignment, Factory I/O Assignment, ICE-COP-2 Boards on page 7-16
Appendix