Computer Security
5-5
Computer Security
A computer security system is available for the Motion 2000 controllers. The system requires
the user to enter a passcode before the controller's parameters can be adjusted.
The controllers are shipped without the security system. However, the security system can be
purchased through MCE's Technical Support Department. Complete installation instructions
are provided with the modification package. The next few paragraphs explain how the security
system works after it is installed.
This message is not related to Computer Security. If this
message is seen on the LCD screen, it means that the Passcode
Request Option has been activated and that a passcode is
required in order to run the elevator on any mode of operation other than Inspection. Please
refer to “Passcode Request Menu” on page 5-62 for more information.
Password
There are two sections that are secured by an 8-digit, alpha-numeric code chosen by the cus-
tomer, Program Mode and System Mode.
When either of these two sections is
accessed, the LCD display will show:
The password is entered using the push buttons as follows:
N Push button Change the position of the cursor to select a digit to set.
+ Push button Increment the selected digit by one.
- Push button Decrement the selected digit by one.
S Push button Check for a match (ENTER).
If an invalid code is entered, the operator will be prompted to re-enter the code. Once a valid
code has been entered, access is granted to the programming options and the password will not
have to be reentered until the Password Timer expires.
PASSCODE REQUEST
PI 8 2O:1OOO1OOO
To Next Page
Loading...
Need help?
General
