Appendix
7-12 Manual # 42-02-1P21
Elevator Security Information and Operation
Building name:
Building location:
Security activation: Key switch Mon: from to
or Tue: from to
Time clock Wed: from to
Thu: from to
Fri: from to
Sat: from to
Sun: from to
Instructions: To gain access to secured floors, follow the steps below while in the elevator car. The steps
may be taken while the car is moving or standing still. Requests for a car from a hallway or corridor are
answered without restriction.
1. While in the car, press the button for the desired floor. If the destination floor is secured,
the button for that floor will flash on/off.
If the button for that floor stays solidly illuminated, that floor is unsecured.
2. While the destination floor button is flashing, enter the security code for that floor
within 10 seconds. Enter the security code by pressing the corresponding buttons on the
panel.
If the code was entered correctly and within the required time limit, the car will immedi-
ately go to that floor. If the code was not entered within the 10-second time limit or was
entered incorrectly, the destination floor button light will turn off after 10 seconds and
the entire sequence must be repeated.
If a mistake is made while entering the security code, simply wait until the destination
floor button light stops flashing and then start the entire sequence again.
To Next Page
Loading...
Need help?
General
