The Computer
5-62 Manual # 42-02-1P21
Passcode Request Menu
The Passcode Request Operation can be used to require a password to be entered in order to
run the car on any mode of operation other than Inspection.
If the passcode option has not been activated for this controller, the Passcode Request Menu
will not appear.
If a passcode has been programmed, the LCD screen will flash
the “PASSCODE REQUESTED” message when Passcode
Request Operation is activated.
In order to clear or set the Passcode Request Operation, the con-
troller must first be placed into the System Mode (see “F3: Sys-
tem Mode” on page 5-60). By pressing the N push button when
the display reads “BUILDING SECURITY MENU,” the Passcode
Request Menu will appear:
Clearing the Passcode With Screen 1 displayed, press
the S push button. If Passcode Request Operation is activated,
the following screen appears:
The first character of the passcode to be entered will blink. The “+” and “-” push buttons will
scroll through the numbers 0-9 and letters A-Z for each character of the passcode. The N push
button will advance to the next character position of the passcode.
Pressing the S push button will cause the program to verify that
the passcode entered was correct. If it was not correct, the fol-
lowing screen will appear:
Pressing the S push button will display Screen 2. Pressing the N push button from this screen
will return the display back to Screen 1.
If the correct passcode was entered, the following screen
appears:
Pressing the N push button will return the display to Screen 1.
The car may now be run on Normal operation mode.
Activating the Passcode With Screen 1 displayed,
press the S push button. If Passcode Request Operation is not
activated, the following display appears:
Pressing the S push button will toggle the display from “NO” to “YES”. Pressing the N push but-
ton while “NO” is displayed will return the display back to the Screen 1. Pressing the N push
button while “YES” is displayed will activate the Passcode Request Operation and return the
display back to Screen 1. With Passcode Request Operation activated, the passcode must be
entered in order to run the car on any mode of operation other than Inspection.
PASSCODE REQUEST
PI 8 20:1OOO1OOO
* PASSCODE *
REQUEST MENU
Screen 1
REQUESTED PASS-
CODE: OOOOOOOO
Screen 2
* INVALID CODE *
S=CONT. N=EXIT
Screen 3
* VALID CODE *
N=EXIT
Screen 4
ACTIVATE
PASSCODE? NO
Screen 5
To Next Page
Loading...
Need help?
General
