NCR 5887 - Page 203

Motorised Card Reader
Cleaning
NCR Personas M Series 5887 Operator Manual 10-9
3 The Supervisor Mode Executive (SME) menu will be displayed
on the operator display.
4 Press the key on the keyboard that corresponds to the
TERMINAL
UTILITIES
option. The Utilities menu will be displayed.
5 Press the key which corresponds to the
TRANSFER INTERFACE
option then go to the front of the ATM. The front display will be
blank.
6 Press the Enter (or equivalent) key on the customer keyboard.
Enter the password 2468 and then select Enter again. The
Utilities menu will be displayed.
7 Press the key on the keyboard which corresponds to the
MAINTENANCE option. The maintenance menu will be displayed.
8 Press the key which corresponds to the CARD READER option.
The Card Reader menu will be displayed.
9 Prepare the cleaning card according to the instructions provided
with it.
10 Press the key on the keyboard which corresponds to the
CLEANING CYCLE option. When instructed to do so, insert the
cleaning card into the card reader.
11 When instructed to do so, remove the cleaning card. A screen
will be displayed giving the results of the cleaning cycle.
12 Select the FDK to return to the TEST menu. If the cleaning card
you are using has only one cleaning side on it, turn the card over
and run the CLEANING CYCLE a second time. When the test is
complete, select the FDK to return to the TEST menu.
13 Select the FDK to return to the
DEVICE menu.
14 Select the FDK to return to the
UTILITIES menu.
15 At the UTILITIES menu, press the key on the keyboard which
corresponds to the TRANSFER INTERFACE option. The control
will be transferred to the rear operator panel with no password
necessary. The
UTILITIES menu will be displayed.
16 Select the FDK to
EXIT and return to the SME menu.