Getting Started
How to Use the Enhanced Operator Panel
NCR Personas M Series 5887 Operator Manual 1-11
When the door is closed, and the ATM is in normal mode the EOP
will be blank.
The Supervisor switch is used to enter the System Application or
State of Health, from where error messages can be accessed.
The reset switch will cause a reset of the whole ATM.
The contrast control is used to adjust the brightness of the display
panel.
Note: To run a program, or a program from any of the subsequent
menus which will be displayed, press the number key or the
Function Display Key (FDK) on the EOP which corresponds to the
option you wish to select.
It is possible to transfer the operator functions from the operator
panel to the front of the ATM using the
TRANSFER INTERFACE
option. This procedure is described in either the NCR publication,
‘APTRA Self-Service Support System Application User Guide’, (B006-
6167) or ‘Supervisor Functions’, (B006-4718) depending on which
software system your ATM is running.
To Next Page
Loading...
