Getting Started
How to Insert and Remove Disks
1-40 NCR Personas M Series 5887 Operator Manual
4 To insert a disk, firmly push the disk into the disk drive as
shown below until the small button ejects slightly.
5 To remove a disk from the disk drive, fully press in the eject
button on the drive. This will eject the disk allowing you to
remove it.
6 Close the drive bay cover by pushing it firmly so that the spring
loaded pins fully locate in their latches as shown below.
Caution This is an ESD (electrostatic discharge) sensitive device, therefore,
after any maintenance or service actions the drive bay cover must be
closed and fully latched home.
7 If fitted, close the disk security latch then lock or seal it as
required by your organization.
8 Close and lock the ATM.
To Next Page
Loading...
