NCR RealPOS - Page 145

Chapter 6: Special Programming 6-13
7. Portsettingsmustbeconfiguredfirstbeforeflashingfirmwaretothescanner.
SelectPortSettingsinthemainwindowandselecttheModifyINIbutton.
8.
SelectoneoftheradiobuttonsundertheCommunicationsProtocolGroupwithin
thePortSettingstab.ForRS‐232communicationprotocol, youcanconfiguremore
settingsundertheRS‐232Settingsgroup.Right‐clickononeofthecellsinthe
tabletoeitherchangetheparametervalueorrestoreittoitsde
faultvalue.