: Default
BASIC SERVICE SETTING DATA
502 Name display on the called station when calling from Sub Line 0
1
Name display of My Line
Name display of Sub Line
Calling Party Name sending to ISDN when making an outgoing
call from Sub Line
0
1
Name of My Line
Name of Sub Line
NOTE: In other than North America, this command is effective when using 8300R4 software or later.
503 Send RBT when the called PS is out of cell (zone) or the power
is off/the called Standard SIP station is in off hook state, the
power is off, or the cable is pulled out
0
1
Not sent
To send
NOTE: Effective only for station-to-station call or originating office on WCS roaming.
504 PS/Standard SIP station No-Answer 0
1
Available
Not available
507 Send calling station number to the analog telephone for Caller
ID-Station when an internal call is terminated.
0
1
Not sent
To send
NOTE: This command is effective only when CM08>603 is set to “0”.
508 Mask indication (*) for Station Authorization Code entry 0
1
To provide
Not provided
509 Call Forwarding-Override when the Call Forwarding-All Calls
is set to the My Line of Multiline Terminal
0
1
Call Forwarding-Override
As per CM08>268
510 Station Hunting-Not Available when the called PS is out of cell
(zone) or the power is off/Station Hunting-Standard SIP station
Off Hook/Power Off/Cable Pulled Out
0
1
Available
Not available
513 ID registration method for IP Station 0
1
Protected Login Mode for All IP Sta-
tions
As per CM15 Y=480
514 Whether the system encodes the station number when IP Sta-
tions login to the network
0
1
To encode (NEC Original method)
Not encoded
515 Whether the system encodes the password when IP Stations
login to the network
0
1
Not encoded
To encode (As per CM08>517)
Continued on next page
To Next Page
Loading...
