: Default
BASIC SERVICE SETTING DATA
581 Number display on the called PS when calling from Sub Line
[8300R3.5]
0
1
My Line Number
As per CM08>502
NOTE: The number displayed on the called PS is as follows when this command is set to “1”.
- My Line Number is displayed when CM08>502 is set to “0”.
- Sub Line Number is displayed when CM08>502 is set to “1”.
583 Whether the calling number is automatically stored or not for
the station call via CCIS
0
1
To store
Not stored
584 Caller ID sent to ISDN telephone when terminating a call from
Single Line Telephone/Multiline Terminal to ISDN telephone
0
1
Calling number assigned by CM12
Y=12, 13/CM50 Y=05
Originating station number
585 Whether the service which is set to a group member station is
effective when the group members are called by Group Feature
Key
0
1
Effective
Ineffective
NOTE: When the second data of CM08>585 is set to 0, the following services are effective.
Call Forwarding-All Calls/Split Call Forwarding-All Calls/Call Forwarding-All Calls of Mobility
Access/Do Not Disturb/Transfer the call to station set Do Not Disturb (CM51 Y=10)/Call Forwarding-
Logout
588 CID Call Back when an incoming call is forwarded, when a
station to which a call terminated is busy, or when a station to
which a call terminated is set Do Not Disturb
0
1
To provide
Not provided
NOTE: CID Call back by this command is available under the following conditions.
• The Multiline Terminal station line is set to Call Forwarding-All Calls/Call Forwarding-Busy Line/
Call Forwarding-No answer/Call Forwarding-IP Station logout when a trunk call is terminated.
• The Multiline Terminal station line is set to Do Not Disturb when a trunk call is terminated.
• The Multiline Terminal station line received the incoming call is busy when a trunk call is termi-
nated.
591 Extension state (Idle/Busy) is displayed immediately to Busy
lamp Field on DESKCON
[8300R2]
0
1
To display
Not displayed
592 Setting of the Caller ID information sending format 0
1
CCITT V.23 modem (Data Format:
ETSI)
Bell 202 modem
NOTE: A system reset is required after setting this command.
Continued on next page
To Next Page
Loading...
