: Default
BASIC SERVICE SETTING DATA
600 Selection of trunk route seized for Call Forwarding-All Calls/
Busy Line/No Answer-Outside, Split Call Forwarding-All
Calls/Busy Line/No Answer-Outside
0
1
By calling party’s tenant/terminating
trunk’s tenant
By Call Forwarding setting station’s
tenant
602 Reset of Queue Limit counter for TAS per tenant 0
1
Not provided
To provide
603 Caller ID/CPN/ANI to Single Line Telephone from CCIS/SIP
Trunk
0
1
To provide
Not provided
606 Link Reconnect-CCIS 0
1
Not provided
To provide
607 Reconnect the CCIS link when a call is connected to UCD
Delay Announcement via CCIS
0
1
To provide
Not provided
608 Call Forwarding type when an incoming call terminates via
CCIS
0
1
As per CM65 Y=37/38/39
As per CM65 Y=23/24/25
624 Alternative Routing when all outgoing trunks of tandem office
are make busy condition
0
1
To provide (CGC sending)
Not provided (CFL sending)
626 In ETSI ISDN Overlap Receiving, whether the system connects
to the calling party when the system does not receive the fol-
lowing DID number within the time set by CM41 Y=0>109,
after the first DID number of the calling party is received
[For EU]
0
1
Not connected
To connect
627 In ETSI ISDN Overlap Receiving, whether the system connects
to the calling party when the DID number of digits received
from ISDN is more than the maximum number of digits
assigned by CM85 Y=0-7
[For EU]
0
1
Not connected
To connect
628 Link Reconnect-Peer-to-peer CCIS 0
1
To provide
Not provided
NOTE: This command is effective when CM08>606 is set to 1.
629 Connected line number indication on DESKCON display in
ETSI ISDN Connected Line Identification Presentation (COLP)
[For EU]
0
1
Not provided
To provide
Continued on next page
To Next Page
Loading...
