: Default
BASIC SERVICE SETTING DATA
702 Ringing signal/Live Record Start signal which includes caller
information (such as station number and kind of calling party)
is sent to VMS
NOTE: Set the second data to “0” to enable Voice Mail Live
Record-CCIS.
0
1
To send
Not sent
703 Ringing signal/Live Record Start signal which includes calling/
forwarding party information (such as station number and kind
of calling party) of opposite office is sent to VMS, when a call
is terminated to VMS via CCIS
NOTE: 1st data=0 is effective only when CM08>379: 0.
0
1
To send
Not sent
704 The following signal is sent to VMS
• Busy signal
When the VMS forwards a call to a station/trunk and the
station/trunk is busy
•Answer signal
When the VMS forwards a call to a station/trunk and the
station/trunk answers
• Release signal
When a station/trunk hangs up while accessing the VMS
NOTE: Set the second data to “0” to enable Voice Mail Live
Record-CCIS.
0
1
To send
Not sent
705 Remote Hold from DESKCON
[North America Only]
0
1
Available
Not available
706 MW lamp control on a station of opposite office from VMS via
CCIS
NOTE: 1st data=0 is effective only when CM08>702: 0 and
CM08>703: 0.
0
1
Available
Not available
708 Number of digits for station number in MCI message format
sent to VMS from CPU RS-232C port
0
1
6 digits
8 digits
709 MCI message format sent to VMS from CPU RS-232C port 0
1
Format with ANI
Format without ANI
Continued on next page
To Next Page
Loading...
