NEC Univerge SV8300 - Page 148

3-92 NWA-033623-001 Rev.8.1
91ch3001.fm
COMMAND CODE
TITLE:
LAN DATA ASSIGNMENT
0B
ASSIGNMENT PROCEDURE:
DATA TABLE:
Y=000
+ 0BYYY + + + + +
2ND DATA
EXE
ST
DEDE
(1-128 digits)
1ST DATA
(2-3 digits)
: Default
Y 1ST DATA 2ND DATA
RELATED
COMMAND
No. MEANING
DATA MEANING DATA MEANING
000 Unit number setting 90 – 01
50
NONE
Unit No. 01
Unit No. 50
Unit No. 01
CM0B
Y=0XX>141
NOTE 1: This command should be set in each unit.
NOTE 2: The registration/clear of this data is available only in off-line mode.
NOTE 3: Set the SENSE switch of the CPU blade to “1-4” when operating the
Unit as Unit No. “01-04” (for Main Unit). The Unit functions as Unit
No. “01-04” regardless of the setting of this data.
NOTE 4: Set the SENSE switch of the CPU blade to “0” after this data setting
when operating the Unit as Unit No. “05-50” (for Remote Unit). The
Unit functions as the Unit No. set by this data.
NOTE 5: Connect PCPro directly to the CPU to be used as a Secondary Unit,
and assign a Unit number by this system data, when using Failover
system. Unit No. 02-04 is not necessary to be assigned Unit number by
this data.
[8300R6]
Continued on next page
OFF LINE
RESET
~
~
FEBRUARY/29/2012
CM0B