: Default
Y 1ST DATA 2ND DATA
RELATED
COMMAND
No. MEANING
DATA MEANING DATA MEANING
0XX 0 : Maintenance Port
XX: Unit No. (01-50)
00 IP Address for the sys-
tem
XXX.XX
...X
NONE
IP Address
(Maximum 15 digits)
XXX.XXX.XXX.XXX=
0.0.0.1-255.255.255.254
192.168.1.1
NOTE 1: This data cannot be entered by CAT when using 8300R1 software.
NOTE 2: When setting the IP address by this data, a period (.) must be entered
between the numbers (example: 255.255.255.254).
01 Subnet Mask for the
system
XXX.XX
...X
NONE
Subnet Mask
(Maximum 15 digits)
XXX.XXX.XXX.XXX=
255.0.0.0-255.255.255.252
No data
NOTE 1: This data cannot be entered by CAT when using 8300R1 software.
NOTE 2: When setting the Subnet Mask by this data, a period (.) must be
entered between the numbers (example: 255.255.255.252).
NOTE 3: When CM0B Y=0XX>00 is set to the default data (NONE), Subnet
Mask for the system is set to 255.255.0.0 regardless of this data setting.
02 Default Gateway for the
system
XXX.XX
...X
NONE
Default Gateway
(Maximum 15 digits)
XXX.XXX.XXX.XXX=
0.0.0.1-255.255.255.254
No data
NOTE 1: This data cannot be entered by CAT when using 8300R1 software.
NOTE 2: When setting the Default Gateway by this data, a period (.) must be en-
tered between the numbers (example: 255.255.255.254).
09 Speed mode for the LAN
Interface
02
03
04
05
15
100 Mbps (Full-Duplex)
100 Mbps (Half-Duplex)
10 Mbps (Full-Duplex)
10 Mbps (Half-Duplex)
Auto Negotiation
20 Whether to allow the
connection with PCPro
0
1
Restricted
Allow
Continued on next page
To Next Page
Loading...
