: Default
Y SERVICE
REST.
CLASS (A)
SETTING DATA
No. MEANING DATA MEANING
228 32-Party Conference Connection by Call Transfer
[8300R5]
00
15
0
1
Restricted
Allow
NOTE: This data is effective for the station of Call Transfer operator from own office. The station of Conference
participants from the different offices via CCIS/IP trunk (P2P CCIS) is allowed to participate in Confer-
ence regardless of this data.
229 RTP route for station-to-station connection using Standard
SIP station
[8300R5]
00
15
0
1
Peer-to-Peer connec-
tion
Via VoIPDB
NOTE 1: To establish Peer-to-Peer connection of station-to-station calling with Standard SIP station, set this
data to “0” for both Standard SIP station.
NOTE 2: When using access codes assigned by CM20 Y=0-3: A263/A264, whether to use Peer-to-Peer connec-
tion or not depends on access codes regardless of this data.
NOTE 3: A reset of the terminal is required after this data setting.
400 Displaying pattern of Caller ID on the LCD of Multiline Ter-
minal before answering or after answering a trunk call
00
15
0
1
7
To display calling
number on upper line
of LCD, calling name
on middle line of LCD
To display calling
name on upper line of
LCD, calling number
on middle line of LCD
Not displayed calling
number and calling
name simultaneously
NOTE 1: Set this data to “0” or “1” when calling number and calling name is displayed at the same time.
NOTE 2: When the second data of CM15 Y=400 is set to 0, set the second data of CM15 Y=136 to 1 (Calling
Name Display).
NOTE 3: When the second data of CM15 Y=400 is set to 1, set the second data of CM15 Y=136 to 0 (Calling
Number Display).
Continued on next page
To Next Page
Loading...
