: Default
Y SERVICE
REST.
CLASS (A)
SETTING DATA
No. MEANING DATA MEANING
218 Call Forwarding-All Calls of Mobility Access call 00
15
0
1
Restricted
Allow
219 Call Forwarding-Busy Line/-No Answer for call forwarding
in Mobility Access Mode
0
1
Restricted
Allow
NOTE: Call Forwarding-No Answer in Mobility Access Mode is effective for 8300R5 software or later.
222 Room Status setting
(Room Cutoff/Do Not Disturb/Message Waiting/Wake Up
Call/Trunk Restriction class change)
00
15
0
1
Allow
Restricted
223 Conference (built-in CPU)
[8300R2]
0
1
Restricted
Allow
NOTE: This data is effective for the station of Conference participants from own office. The station of Conference
participants from the different offices via CCIS/IP trunk (P2P CCIS) is allowed to participate in Confer-
ence regardless of this data.
224 Calling Number Display when an internal incoming call is ter-
minated to the sub line of Multiline Terminal
[8300R3.5]
00
15
0
1
Allow
Restricted
NOTE: A reset of the terminal is required after this data setting.
225 Calling Number Display when an external incoming call is
terminated to the sub line of Multiline Terminal
[8300R3.5]
00
15
0
1
Allow
Restricted
NOTE: A reset of the terminal is required after this data setting.
226 Preset Do Not Disturb-Override
[8300R5]
00
15
0
1
Restricted
Allow
NOTE: Preset Do Not Disturb-Override is allowed for DESKCON regardless of this data.
227 Select the call termination to Suite Room station while one of
the suite room stations is busy
[8300R5]
00
15
0
1
Ring an idle station
Hearing busy tone
NOTE 1: When this data is set to “1”, Call Forwarding-Destination specified by CM51 Y=35 is available.
NOTE 2: Set this data for a Suite Room master station.
Continued on next page
To Next Page
Loading...
