: Default
Y PS/STANDARD
SIP STATION
No.
SETTING DATA
RELATED
COMMAND
No. MEANING DATA MEANING
32 Digest authentication to the
Standard SIP station
[8300R3.5]
X-XXXXXXXX
(Standard SIP
Station No.)
02
03
15
Allowed
Restricted
Allowed
CM10 Y=04
NOTE 1: Be sure to set the second data to “03” (Restricted) when not executing the digest authentication.
NOTE 2: To execute the digest authentication, settings of user name and password for Standard SIP station are
required.
- User name: set the Standard SIP station number assigned by CM10 Y=04.
- Password: set the password assigned by CM2B Y=00.
NOTE 3: Be sure to reset Standard SIP station when this data setting is changed.
90 A combination of PS station
number that is converted
from NEAX 2000 IPS and
SV8300 PS station number
X-XXXXXXXX
(Primary Subline
PS Station No.)
XX...XX
CCC
NONE
PS station No.
(assigned by CM1C from
NEAX 2000 IPS)
Clear
No data
CM10 Y=04
NOTE 1: This command is used when the system data of NEAX 2000 IPS is converted by System Data Converter
of PCPro.
NOTE 2: PS station numbers are controlled by the following two numbers;
- The incoming/outgoing number of PS is controlled by the first data (PS Station No.) of this command
as well as NEAX 2000 IPS.
- A PS station number between the ZT-PS is controlled by the PS station number assigned by CM1C
of NEAX 2000 IPS.
NOTE 3: If a PS station number is cleared by this command, A PS station number assigned by CM10 Y=04 is
assigned to the PS (a PS number is controlled by one number).
It is recommended to clear a PS station number by this command and control the PS by one station
number.
NOTE 4: This data setting is not required when assigning a PS station number by SV8300.
To Next Page
Loading...
